User has the facility to choose undesirable float length and the system would highlight its occurrence in the Card image file.
Further a manual / automatic command is available for eliminating the float length. Simply specifying position to cut the float & Choosing the Break button would automatically clear all the extra length floats from the CI file...
It is a software innovation that comprehensively solves the problem of detecting and binding floats in fully automatic mode. Depending on the weaves used, the floats are found and analyzed. According to this analysis the floats are bound exactly at their transition points, which avoids creating new floats.
The binding points themselves - depending on the weaves - can be set to only occur on certain ends or picks. Even float lengths that are smaller than the ones appearing within a regular weave will be found and edited properly. Regular weaves, therefore, will not be modified.
